: Open the loader and select the correct "COM Port" and "Baud Rate" (typically 115200).
: Ensure the loader is specifically for the "Rear USB" version; using a loader for the "Front USB" version can cause a mismatch and "brick" the device. : Open the loader and select the correct
: Use an RS232 cable (or USB-to-RS232 adapter) to connect your computer to the receiver's maintenance port. : Do not disconnect the power or the
: Do not disconnect the power or the cable during the flashing process, as this can permanently damage the receiver's internal flash memory. Important Precautions : Select the software file (often a
: A leading community for satellite software in the Middle East where you can find specific loaders and "dump" files for the Starport 9400 series.
: Click "Start" on the loader, then plug in or turn on the receiver's power switch to begin the data transfer. Important Precautions
: Select the software file (often a .bin file) you wish to flash.