This system allows for repeatable parallel cuts without manually measuring and marking each piece.
: Crucial for accuracy. Align the stops with a pencil mark on a fresh splinter guard cut. Use a flathead screwdriver to fine-tune the bracket position if the measurement doesn't match the scale. 3. Operational Best Practices UwzCWe4JQ2VYrg4oyh4
: If you must connect two rails, use Guide Rail Connectors. While functional for long rips, a single long rail is always more accurate. This system allows for repeatable parallel cuts without
: The set includes a Parallel Guide (main extension) and Extensions for wider cuts. Installation : Slide the bracket into the rear groove of the guide rail. Use a flathead screwdriver to fine-tune the bracket
: When using an MFT/3 Multi-Function Table, ensure the guide rail is long enough to clear the board at both the start and end of the cut to prevent kickback. 4. Alternatives & Enhancements Festool Parallel Guides
Insert the tab into the middle groove and tighten the green knobs. Adjust the stop to your desired measurement.
: Always start with a clean "reference edge" by trimming the factory edge of your plywood before making parallel cuts.