Delta 52 611 Sander Manual 🎯 Essential

Insert the support rod into the base and tighten the socket head screw.

Slide the table assembly onto the rod and secure it with the secondary socket head screw. Delta 52 611 Sander Manual

: Must be secured to a workbench or floor; if using a workbench, drill four 3/8-inch holes to permanently bolt the base. 2. Setup and Installation Insert the support rod into the base and

Maintain a minimum clearance of between the table and the sanding belt for safety. if using a workbench

: Tilts 45° out (away from belt) and 20° in (toward belt).

: Use a 3-wire grounded extension cord. Ensure the gauge is heavy enough to prevent voltage drops and overheating (refer to the Delta Abrasive Belt Manual for specific gauge charts). 3. Operational Safety 6" Abrasive Belt Finishing Machine